The Service Tool is a Canon resetter that is very useful in repairing various damage errors that are commonly experienced by Canon printers. Printer errors are common, especially when the printer is often used for a long time.
Error 002 is a common error when using the Canon Service tool. This error can have a variety of causes, including problems with the printer’s firmware or hardware, problems with the Service tool itself, or conflicts with other software on the computer.
To find out the cause of the error 002 service tool, you can pay attention to the following steps:
- Make sure the printer is turned on and properly connected to the computer.
- Try restarting the computer and then rerunning the service tool resetter.
- Try running the service tool in compatibility mode for older versions of Windows.
- Look for updates to the printer firmware and install them if needed.
- If using a USB connection, try using a different USB cable or port.
- Make sure you are using the latest version of the Canon service tool.
- Try to use another version of the service tool to avoid error code: 002 (compatibility issue), Each version of the service tool has the supported canon series.
The available version of the Canon service tool:
How to Fix Error Code “002” Canon Service Tool as follows;
After checking some of the problems mentioned above, run the resetter Canon service tool again.
- Press the Power Button on the printer, and Plug the USB cable into another USB port on the computer.
- Run the Canon Service Tool again
- Done
This is an article about tutorials for dealing with error 002 on the Canon Service Tool, I hope this is useful.